Rotate phone


Our flat steels: cold-drawn, hot-rolled and forged

Flats Cold-drawn +C
5x2 mm a 400x40 mm
3/16"x1/8" mm a 12"x2"
Thickness Max 80 mm/3"
Lucefin acciai finiti a freddo
Flats Hot-rolled and forged
20x4 mm a 400x100 mm
Lucefin acciai finiti a caldo


The cold-drawn flat bars offered by the Lucefin Group are obtained from coil or bar. The sizes available range from 5×2 mm to 400×40 mm (3/16″ x 1/8″ to 12″ x 2″), with a maximum thickness of 80 mm (3″).
Cold-drawn flats are normally supplied with a sharp edge and in natural state; thanks to its state-of-the-art equipment, Lucefin can also supply products with specific heat treatment (stress relieving, annealing, normalization, quenching and tempering) and with automatic US control on each individual bar.
Upon request, the bars can be supplied in surface class 2.
The Group can supply flats according to customer’s specification or with special shapes (with radius corners, round-edged, shaped to drawing, etc. GO TO OUR SPECIAL PROFILES SECTION).
Commercial length is 3 or 6 m; fixed lengths can be supplied upon request.

Some of the most common steel grades we can supply are:

Other steel grades available upon request.


The available range goes from 20×4 mm to 400x100mm. Bar lengths is approx 6 m; thanks to the number of cutting centers operating in each warehouse of the Group, it is possible to supply bars cut-to-size.


via Ruc 30, Esine (BS) ITALY


R.E.A. BS 319721 CAP. SOC. 6.240.000 I.V.

Steel bars